Quick Start Guide

This section is for users already familiar with CMake and may have built earlier versions of RTI Connext DDS Micro. The sections following describe the process in detail and is recommended for everyone building RTI Connext DDS Micro.

It is assumed that the RTI Connext DDS Micro source-bundle is downloaded and installed and that CMake is available.

1. Make sure CMake is in the path.
2. Unix:

       cd <rti_me install directory>/source/unix 
       resource/scripts/rtime-make --target self --name i86Linux4gcc \
                   -G "Unix Makefiles" --build
   

   Windows:

       cd <rti_me install directory>\source\windows
       resource\scripts\rtime-make --target self --name i86Win32 \
                   -G "NMake Makefiles" --build
   

3. The RTI Connext DDS Micro libraries are available in:

       <rti_me install directory>/source/lib/MyFirstBuild
   

NOTE: rtime-make uses the the specified with –name to determine a few settings needed by RTI Connext DDS Micro. Please refer to Preparation for a Build for details.

For help, use:

    resource\scripts\rtime-make --help

To list available targets use:

    resource\scripts\rtime-make --list

For help for a specific target, except self, use:

    resource\scripts\rtime-make --target <target> --help