Installing the |rti_me_h| Package
=================================

|rti_me| is provided in the following target package: 

``rti_connext_dds_micro-4.0.1.rtipkg``

You must first install |rti_core_pro| 7.3.0 before installing
``rti_connext_dds_micro-4.0.1.rtipkg``. 

.. If SDK packages are included, add an additional note: You must first install
   |rti_core_pro| and ``rti_connext_dds_micro-4.0.1.rtipkg`` before
   the corresponding security SDK packages can be installed.

Once installed, you will see a directory ``rti_connext_dds_micro-4.0.1`` in the |rti_core_pro| 
installation directory. This installation directory contains this 
documentation, the *rtiddsgen* code generation tool, and example source code. 

Note that a JRE is needed to execute *rtiddsgen*. The default JRE is the JRE installed in the 
*Connext Drive* or |core_pro| installation where |me| is installed. If a different JRE is needed, 
please refer to section :ref:`section-rtiddsgen` for more information about *rtiddsgen*.

.. note::

   RTI strongly recommends that you copy the |me| installation directory outside of the 
   |core_pro| installation. It may not be desirable to build |me| libraries inside the 
   |core_pro| directory due to patches, lack of write access, or other factors.