5.6.2. Transport Registration

RTI Connext Micro supports different transports and transports must be registered with RTI Connext Micro before they can be used. A transport must be given a name when it is registered and this name is later used when configuring discovery and user-traffic. A transport name cannot exceed 7 UTF-8 characters.

The following example registers the UDP transport with RTI Connext Micro and makes it available to all DDS applications within the same memory space. Please note that each DDS applications creates its own instance of a transport. Resources are not shared between instances of a transport unless stated.

For example, to register two UDP transports with the names myudp1 and myudp2, the following code is required:

DDS_DomainParticipantFactory *factory;
RT_Registry_T *registry;
struct UDP_InterfaceFactoryProperty udp_property;

factory = DDS_DomainParticipantFactory_get_instance();
registry = DDS_DomainParticipantFactory_get_registry(factory);

/* Set UDP properties */
if (!RT_Registry_register(registry,"myudp1",
                          UDP_InterfaceFactory_get_interface(),
                          &udp_property._parent._parent,NULL))
{
    return error;
}

/* Set UDP properties */
if (!RT_Registry_register(registry,"myudp2",
                          UDP_InterfaceFactory_get_interface(),
                          &udp_property._parent._parent,NULL))
{
    return error;
}

Before a DomainParticipant can make use of a registered transport, it must enable it for use within the DomainParticipant. This is done by setting the TransportQoS. For example, to enable only myudp1, the following code is required (error checking is not shown for clarity):

DDS_StringSeq_set_maximum(&dp_qos.transports.enabled_transports,1);
DDS_StringSeq_set_length(&dp_qos.transports.enabled_transports,1);
*DDS_StringSeq_get_reference(&dp_qos.transports.enabled_transports,0) =
                                                 REDA_String_dup("myudp1");

To enable both transports:

DDS_StringSeq_set_maximum(&dp_qos.transports.enabled_transports,2);
DDS_StringSeq_set_length(&dp_qos.transports.enabled_transports,2);
*DDS_StringSeq_get_reference(&dp_qos.transports.enabled_transports,0) =
                                                 REDA_String_dup("myudp1");
*DDS_StringSeq_get_reference(&dp_qos.transports.enabled_transports,0) =
                                                 REDA_String_dup("myudp2");

Before enabled transports may be used for communication in Connext Micro, they must be registered and added to the DiscoveryQos and UserTrafficQos policies. Please see the section on Discovery for details.