Solutions

What does "icmp-response bandwidth limit" mean?

Note: Applies to RTI Connext 4.x and above. Specific to LynxOS . The error message " icmp-response bandwidth limit " in LynxOS is caused by too many messages sent to ports that are not being listened on by an application. LynxOS sends an icmp-response packet for each incoming message and when those ...
sara
Thu, 01/17/2013 - 07:38
5017 reads — 0 comments

Does RTI Connext use IGMP messages?

Note: Applies to NDDS 3.x, RTI Connext 4.x and above Yes, RTI Connext will cause IGMP messages to be sent, allowing routers to appropriately handle multicast traffic delivery. The RTI code does not send the IGMP messages itself, but the host's network stack should send them when needed. When RTI ...
sara
Thu, 01/17/2013 - 07:27
5204 reads — 0 comments

How do I copy from a sequence to an array?

Note: Applies to RTI Connext 4.x and above, C and C++ APIs Statically allocated arrays For C, use FooSeq_to_array . For C++, use FooSeq::to_array . Dinamically allocated arrays There is an easy way to copy from sequence into an array. RTI Connext will always create a contiguous internal buffer for ...
aida
Thu, 01/17/2013 - 07:24
7111 reads — 1 comment

Why does my keyed data type behave as if there is no key?

Note: Applies to RTI Connext 4.x and above These are some common errors when specifying the key in the IDL: In the IDL file, you must use //@key after the key field. Do not use a space between any of these characters: //@key Also note that the directive is case-sensitive — use all lower case. Only ...
belen
Thu, 01/17/2013 - 07:18
3060 reads — 0 comments

How can I resolve problems with QNX applications that use shared memory?

Note: Applies to RTI Connext 4.x and above If you have an RTI Connext application running on a QNX machine and it is unable to communicate with other applications running on the same machine started by another user, or if your application fails to start (with an error related to shared memory), ...
sara
Thu, 01/17/2013 - 07:15
5915 reads — 0 comments

Why are my LynxOS applications not communicating?

Note: Applies to RTI Connext 4.x and above. The LynxOS version does not have a multicast address in its peer host list by default. You need to modify the initial_peers list in the Discovery QoS policy to either include the multicast address, or to explicitly list the hosts that need to communicate. ...
aida
Thu, 01/17/2013 - 07:13
2152 reads — 0 comments

How do I restrict RTI Connext to use only a subset of interfaces?

Note : Applies to RTI Connext 4.x and above. On a machine with multiple NICs, you can restrict RTI Connext traffic to a subset of the available network interfaces (NICs). For example, this would allow you to segregate DDS traffic from other application-specific data. Selecting specific NICs ...
Juanjo Martin
Thu, 01/17/2013 - 07:08
20155 reads — 1 comment

Pages